1C assembly foam PUR B2
ASMBYFM-1C-PU-B2-AT3-750ML
Prices for customers after login
Register now and access more than 2,000 products
Hardened PU foam should be protected against UV exposure by painting over or sealing with e.g. silicone, polyurethane, acrylic or MS polymer.
Insulation, assembly and foam filling of window and door frames and windowsills, foam filling of cavities such as wall openings, roof finishings, door casings, pipe ducts or roller shutter boxes.
The adhesion surfaces must be clean, dry and load-bearing. Slight moistening of the surface improves adhesion and hardening, as well as the cell structure of the foam. Screw the can tightly onto the thread of the can and shake the pistol well around 30 times so that the can contents are mixed and an optimal foam quality is achieved. Adjust the foam bead with the setting screw and spray the foam out using the trigger. Only fill joints and cavities up to a third as the foam will expand. Cut off any excess, fully hardened foam with a knife.
Chemical basis | Polyurethane |
Smell/fragrance | Characteristic |
Can be cut after | 30 min |
Min. processing temperature | 5 °C |
Max. processing temperature | 25 °C |
Contents | 750 ml |
Building material class | B2 - Normally inflammable |
Shelf life from production | 12 Month |
Pipe clamp, two-part, with rubber
Car windscreen wiper Flatblade Pro
Decorative trim adhesive tape
3/8 inch spark plug socket wrench insert
1C cutter knife with slider
3/4-inch impact socket wrench insert
Nitrile chemical protective glove
Electric hammer drill EHD 40 Combi
H07RN-F CEE extension
Submersible pump Type HS
