Premium flat chisel with SDS-max drive arbor
Flat chisel Premium Max
FLCHIS-MAX-HEX-L280-W25MM
ZEBRA
Register now and access more than 2,000 products
Up to 30% higher removal rate
Vibration damping
The buffer section is designed to have a lower hardness level (approx. 48 HRC). The higher level of elasticity means that this section is effective at damping any vibrations that occur, thereby significantly lowering the risk of breakage at the insertion end.
Considerably longer service life
The insertion end is designed to be harder (approx. 52 HRC), which extends the service life considerably.
Chisels remain sharp
The working area made of 60 HRC quality steel is extremely hard and therefore particularly tough.
Minimal risk of sticking in materials in comparison with round versions
Datasheets(X)
For softer materials. Can also be used for "marking" masonry to be knocked out. For general breaking-up and breaking-through work (spiking, mortising, knocking out, pounding, breaking open, breaking out etc.)
Length | 280 mm |
Width | 25 mm |
Tool holding device | Suitable for SDS-max |
Last viewed
Premium flat chisel with SDS-max drive arbor
Tap DN 45 thread for 5 l and 10 l plastic canisters
ASSY® 3.0 zinc-plated blue chipboard screw
Acetate silicone Anti fungus
Hexagon nut DIN 934, A4 stainless steel, plain
Hand tap, second tap HSS DIN 352
Silicone fluid silicone spray
Corrosion protection coating Zinc 300
Impact wrench, pneumatic, spare parts
Pneumatic impact screwdriver DSS 3/4 inch H