For detailed information, other images and documents, please select individual articles from the following table.
Register now and access more than 2,000 products
Variants
Register now and access more than 2,000 products
An adhesive for virtually every type of plastic
- Simple handling of various adhesive types
- Can be used for repairs and structural bonding
Special positive mixer
- Optimal mixing of the smallest volumes
- Little adhesive wastage
Fast-curing
Further processing, such as sanding, possible after a short time
Outstanding resistance to chemicals
Resistant to a range of liquids, such as petrol, many lubricating oils and ethyl acetate
Solvent-free
In some cases, adhesion issues may be encountered due to the coatings and release agents used in the plastic production process. Not suitable for PE (polyethylene), PP (polypropylene) or PTFE (polytetrafluoroethylene) plastics. Check material compatibility on a non-visible area if necessary.
The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications as well as storage and usage conditions, we do not assume any liability for a specific application result. Any technical information or advice provided by our free customer service shall be provided to the exclusion of any liability, unless the advice or information is part of our contractually agreed scope of services or the advisor was acting wilfully. We ensure the consistent quality of our products. We reserve the right to make technical changes and further developments to our products.
Cars:
Spoilers, radiator grills, panel clips, bumpers, brackets on headlights and radiators etc.
Trucks and buses:
Skirt panels, bumpers, air intake pipes, wheel arches etc.
Motorbikes:
All panelling
The substrate must be capable of bearing loads and must be clean, dry and free from grease and rust. Old adhesive residues must also be removed. To do so, clean the surface with the plastic cleaner and apply the primer. The flash-off time must be observed. Discard some adhesive before screwing on the mixing nozzle. The first 2 cm of adhesive dispensed from the mixing nozzle should also be discarded. When applying the adhesive, the mixer should remain in the adhesive to prevent bubbles forming. Observe the work instructions.
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!