Welcome to Würth Sri Lanka For trade customers only

Adhesive remover spray

Adhesive removal spray

Art.-no. 0893141

Prices for customers after login

Adhesive remover spray

Art.-no. 0893141

Prices for customers after login



Exclusively for trade customers

Register now and access more than 2,000 products

Easily removes hardened hot-melt adhesive from the paint surface

Check rubber and plastics for material compatibility.

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Product information

Würth Catalogue(X)


Safety data sheet

Application area

Special product for loosening bondings in indoor and outdoor use on vehicles, motor homes, campers, on technical equipment and on leisure goods.


Use a plastic wedge to slightly lift the hot-melt adhesive on a certain area. Spray the adhesive remover specifically into the gap of the hardened hot-melt adhesive and let it take effect briefly. The adhesive remover spreads into the gaps and loosens the adhesive residue from the surface. The adhesive residue is removed in one piece from the surface in a matter of seconds. Therefore, there is no need for a time-consuming removal process involving a hair-dryer, spatula and cleaner.


150 ml



Chemical basis



0.69 g/cm³ / at 20°C

Shelf life from production

24 Month

Suitable glove:

Nitrile chemical protective glove
Nitrile chemical protective glove
Permeation level: 6
Cotton velour lining
Nitrile chemical protective glove, heavy-duty
Nitrile chemical protective glove, heavy-duty
Permeation level: 6
Long, heavy-duty design
Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.
Measured breakthrough time
Permeation level
< 10 min
≥ 10 min
≥ 30 min
≥ 60 min
≥ 120 min
≥ 240 min
≥ 480 min

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.
Art.-no. Cust. Mat. No.

Hazardous Material

Product information

Würth Catalogue

Catalogue page as PDF  | 


Datasheets ()

CAD data  | 




Technical information