Gravel throw and underbody protection
Gravel guard and undercoating
Register now and access more than 2,000 products
- Excellent adhesion, quick skin formation
- Can be painted over with many commercially available, solvent-based and water-based one-component and two-component top coat paints
- Suitable for oven drying briefly at 40°C to 60°C
- Highly sandable once fully dry
Tip for pros
- Various structures can be sprayed by changing the distance or pressure
- The colour will become darker by staining it with clear varnish
Do not spray on joints, engines, gears and brake systems. After use, turn the can upside down and spray until the valve is empty. Do not dilute, or mix with water or paint. The product can be painted within 24 hours. It can then only be painted once it has been sanded and cleaned.
The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.
For repairing and restoring the original structure and for protecting against stone chips and corrosion in all visible areas, e.g. front and rear aprons, side members, bumpers and chassis on cars, trucks and buses. Ideally suited for use as an anti-humming compound for wheel wells and chassis.
Shake well before use. The surface must be clean, dry and free from rust and dust. Spray a very thin first coat for improved adhesion and let it flash off for approx. 3 minutes. Then apply the next coat. Allow each intermediate coat to flash off. Operating pressure: 2-4 bar. Optimum spraying distance: 30 cm. The best spraying results are achieved at a processing temperature of 15-25°C.
Weight of content
Max. processing temperature
Min./max. spraying distance
Can be varnished after
1.5 h / at 20°C and 65% relative humidity
Conditions for drying time
at 20°C and 65% relative humidity
0.83 g/cm³ / at 20°C
Min./max. temperature resistance
-40 to 90 °C
Shelf life from production/conditions
36 Month / at 5°C to 35°C
Conditions to maintain shelf life from production
at 5°C to 35°C
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
Plus disposal costs -,-- per selected packing unitCust. Mat. No.
TX bit C 8.0 (5/16 inch) with hole
Maintenance set 693
Circlip pliers, shape A for shaft circlips
Precision feeler gauge
Cutting disc for stainless steel Basic
Maintenance set 7 pieces
Compressed-air filter / Regulator Semi-automatic
1/2 inch ratchet With turntable switching
Radiator Coolent Water Based