Welcome to Würth Sri Lanka For trade customers only

Paintable body sealant

Paintable bodywork sealant

Art.-no. 0892010
EAN 4053479466279

Prices for customers after login
Paintable body sealant

Art.-no. 0892010

Prices for customers after login

Exclusively for trade customers

Register now and access more than 2,000 products

Sealant for true-to-original reproduction of the brushed texture from the factory.
  • Fast drying

  • Can be painted over after one hour

  • Silicone-free

  • Permanently elastic

  • Easy to spread

  • Suitable for application with the brush

  • Resistant to water and mineral oil

  • Adheres well to bare, primed and painted metal

  • Basis: Nitrile rubber

The product is not UV-resistant, but can be overpainted for protection against UV radiation.

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Product information

Würth Catalogue(X)


Certificates/ Documents



Application area

Suitable for sealing metal joints, scratches, overlaps and spot weld seams on front and rear skirts, the boot floor, the entire undercarriage, in the passenger compartment, on the sidewalls and on the wheel wells.


The base material must be clean, dry and free of grease. For more information, please refer to the technical data sheet.

Chemical basis

Nitrile natural rubber


Light grey (bright grey)



Min./max. temperature resistance

-25 to 80 °C

Max. short-term temperature resistance

150 °C

Resistance against

Mineral oils

Shelf life from production/conditions

24 Month / well-ventilated storage area, 20°C

Min. flashing point

-20 °C



Recoatable/Can be painted over


Suitable glove:
Nitrile chemical protective glove With cotton velour finish inside
Nitrile chemical protective glove With cotton velour finish inside
Permeation level: 6
Nitrile chemical protective glove Long, heavy-duty design
Nitrile chemical protective glove Long, heavy-duty design
Permeation level: 6
Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.
Measured breakthrough time
Permeation level
< 10 min
≥ 10 min
≥ 30 min
≥ 60 min
≥ 120 min
≥ 240 min
≥ 480 min

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.

Cust. Mat. No.

Hazardous Material

Product information

Würth Catalogue

Catalogue page as PDF  | 


Datasheets ()

CAD data  | 

Certificates/ Documents



Technical information